ECLIPSE #9800i-GENESIS

The Eclipse i-Series model #9800i-GENESIS is the newest Intelligent Monitoring & Flushing Station Kupferle offers to maintain safe residual levels and remove possible DBPs from consumers’ water. This permanently installed station incorporates a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule. Using the Programmable Logic Controller (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time and a maximum flushing duration. The unit will then operate under these parameters and will flush when detected residuals are below minimum programmed levels and flush only the exact amount of water needed until desired residuals are attained. All residual and flushing data is recorded and can be transferred to Microsoft Excel via a micro-SD card or can be transmitted using a SCADA system. Thermal enclosure has a insulation rating of R-9 and is equipped with a 250 Watt high efficiency fan/heater and four zone thermostats. Unit is self powered incorporating a water turbine and a 24VDC battery bank (no outside power source needed). The unit uses any flushed water to run the turbine which charges the batteries that provide power to the analytical equipment. Additional analyzers/sensors can be incorporated including, but not limited to: temperature, pH, psi, turbidity, conductivity and ORP. Sampling lines are heated using self-regulating heat trace. Unit is fully maintainable from above ground.

Options

• Temperature Sensor
• PSI Sensor
• pH Sensor
• ORP Sensor
• 4 Electrode Water Conductivity Monitor
• Water Turbidity Monitor
• Valve Rated at 220 psi
• Check Valve (Single)
• Upgraded RA-22 PLC w/SCADA hardwired I/O

ECLIPSE #9800i-GENESIS PHOTO GALLERY
ACCESSORIES