ECLIPSE #9800WC-i

9800WC-i_1The Eclipse i-Series model #9800WC-i is one of the many new Intelligent Flushing & Monitoring Stations Kupferle offers to maintain safe residual levels and remove DBPs from consumer’s water. This permanently installed station incorporates a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule. Using the Programmable Logic Control (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time and a maximum flushing duration. The unit will then operate under these parameters and will flush only when detected residuals are below minimum prescribed levels and flush only the exact amount of water until desired residuals are attained. All residual and flushing data is recorded and can be transferred to Microsoft Excel via a micro-SD card or can be transmitted using a SCADA system. The unit is housed in a UV-resistant lockable enclosure and requires 120VAC line power or a 24VDC solar panel power source. Unit is fully maintainable from above ground.

Documents

Options

• pH Sensor
• Pole-mounted solar power ready system
• Dechlorination basket (part #X9815)
• Dechlorination inline drain
• Valve rated at 220 psi (part #9515)
• Upgraded RA-22 PLC w/SCADA hardwired I/O

ECLIPSE #9800WC-i PHOTO GALLERY
ACCESSORIES