Eclipse #9800i

9800i_1The Eclipse i-Series model #9800i is one of the many new Intelligent Flushing & Monitoring Stations Kupferle offers to maintain safe residual levels and remove DBPs from consumers’ water. This permanently installed station incorporates a built-in Amperometric chlorine sensor to measure and record disinfectant residual levels based on a programmed sampling schedule. Using the Programmable Logic Control (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time and a maximum flushing duration. The unit will then operate under these parameters and will flush when detected residuals are below minimum prescribed levels and flush only the exact amount of water needed until desired residuals are attained. All residual and flushing data is recorded and can be transferred to Microsoft Excel via a micro-SD card or can be transmitted using a SCADA system. Additional sensors available to monitor attributes such as pH, PSI, temperature, conductivity, turbidity, and more. Thermal enclosure has an insulation rating of R-9 and is equipped with 150 Watt heater/fan and four zone thermostats (requires 120VAC line power). Sampling lines are heated using self-regulating heat trace. Unit is self-draining, non-freezing based on depth of bury and is maintainable from above ground.  Chlorine analyzers comply with the EPA Method 334.0 which defines methods suitable for use in on-line chlorine residual monitoring for reporting purposes.  PATENTED

Request a Quote!

Request a Demo!



• Depths of bury over 3′, per 6″
• Pole-mounted solar power ready system
• Dechlorination basket (part #X9815)
• Dechlorination inline drain
• Valve rated at 220 psi (part #9515)
• Check Valve